Другие журналы

. A B C D E F G H I J K L M N O P R S T U V W Y Z К М С Т


Bench test results of a sixteen-step gearbox with automatic control
Engineering Education # 12, December 2013
DOI: 10.7463/1213.0671097
The paper presents theoretical dependences which allow to calculate the main parameters of a pneumatic actuator of a multi-step mechanical synchronized gearbox, depending on the parameters of an engine, a gearbox and conditions of traveling resistance during the synchronization process with alternating pressure and various air escapes into a pneumatic cylinder: critical and subcritical escapes at constant pressure. Results of theoretical investigations and bench tests were compared. Calculated values of synchronization time at separate stages and at the whole cycle of gear actuation differed from experimental data no more than by 10-25%.
Investigation of the possibility of gear change during movement of a car with use of indexes which characterize actual and kinematic interval of revolutions of transmission’s drive parts
Engineering Education # 11, November 2012
DOI: 10.7463/1112.0486309
The paper presents differential equations of vehicle’s motion at the moment of gear shifting during ascent or descent of a vehicle. The influence of time of gear shifting on the value of vehicle's speed variation and generalized parameter – the actual interval of revolution of transmission’s drive portion in cases of gear shifting to the speed-increasing or speed-reducing gear. Analytical dependences between the size of the actual interval of revolution, parameters of the gear box, car and external resistance factors were obtained. Conclusions regarding the influence of the actual interval of revolution on the output parameters of transmission and vehicle were drawn.
Innovative "KOM-NAMI" gearboxes with mechanical and automatic control
Engineering Education # 09, September 2011
The article tells about original constructions of non-blocking synchronizers, planetary space-saving demultiplicators with inbuilt synchronizer and high load-carrying capability, “KOM-NAMI” space-saving gearboxes that were developed on the basis of these devices with prospective qualitative characteristics. There is information about gearboxes for light commercial vehicles, buses and multiple-speed gearboxes for heavy dump trucks and tractor-lorry-trailer combinations. The paper describes clarified analytical dependences that are based on minimal source data available from any advertising pamphlet or catalogue and could be used for estimation of load-carrying capability of an aggregate or its elements. This could be used for calculating of metrics impartial assessment including gears contact and bending durability factors that are necessary for design of new and prospective gearboxes.

Engineering Education # 02, February 2011
elibrary crossref ulrichsweb neicon rusycon

About Project
Rambler's Top100
Phone: +7 (915) 336-07-65 (строго: среда; пятница c 11-00 до 17-00)
© 2003-2024 «Наука и образование»
Перепечатка материалов журнала без согласования с редакцией запрещена
 Phone: +7 (915) 336-07-65 (строго: среда; пятница c 11-00 до 17-00)